RapidView Tech Tips
step-by-step instructional videos
Our talented technicians take the time to sit down and give you step by step instructions on how to do less complicated repairs on your own! Subscribe to our YouTube channel so you never miss another Tech Tip video in the future!
Subscribe Today!
Featured:
Installing a LISY Cable
More Tech Tips
- All
- Cable
- Cameras
- Controllers
- Tractors
- Other
Removing MP4 Spring Coupling
In this video, RapidView Service Technician, Jerry Lockwood will demonstrate how to remove the spring coupling from your MP4 cable, before you begin a re-termination.
BP 3.5 Configuration
In this Tech Tip, RapidView Service Technician, Jerry Lockwood, talks you through the configuration modes on the BP 3.5 Controller.
How to Change A Wheel Seal
In this tech tip video, RapidView Master Service Technician, Josh Taylor, shows you how to change a wheel seal on a KRA75, T76, LISY150, or PANORAMO 2 tractor.
How to Un-install & Re-install Mainline Cable
In this Tech Tip, RapidView Service Technician, Nikk Goff, talks you through how to un-install and re-install a mainline cable into a KW 305 drum.
How to Check the Software on Your RapidView IBAK System
This Tech Tip video shows you how to check the currently installed software on an EDE 7, BS3.5 or BS7, MiniLite, BS5, and BE3 systems.
Cleaning Your Tractors
Master Service Technician, Josh Taylor, shows you how to properly clean a KR75 Series tractor, T76 Series tractor, and a LISY Series tractor.
How to Operate a BK 3.5.1 Recorder
Master Service Technician, Josh Taylor, shows you how to operate the built in recorder with the BK 3.5.1 control system.
Lubricants
In this Tech Tip segment, Service Technician Matthew Jensen explains the differences in equipment lubricants and their typical applications.
Changing A Light Housing
Service Technician Matthew Jensen explains how to properly change a light housing on your camera in this Tech Tip.
Installing a Tractor Lift
In our last video, Josh explained the proper way to install a LISY 3 attachment to a T76 crawler. In this video Josh explains how to do the opposite: revert back to the original lift.
Installing a LISY 3
Master Service Technician Josh explains the proper way to install a LISY 3 to your T76 Tractor.
Changing Your Controller Back To NTSC
In this Tech Tips segment, Josh explains how to change your controller from PAL mode to NTSC.
Good Equipment vs Bad Cables
Josh explains how and why to avoid the mistake of hooking up bad cables to good equipment and how to identify in which of these the problem truly lies.
Keep Your Air Pump Clean
This month's Tech Tip has Master Service Technician Josh Taylor describing a simple way to ensure that your equipment remains running day after day.
Cleaning Equipment
RapidView Service Department Manager, Rick Norman provides you with a simple tech tip that can keep your RapidView IBAK products running smoothly. Sometimes the smallest amount of preventative maintenance can go a long way at saving you time and money!
PANORAMO SI Spacers
In this video, Master Service Technician, Josh Taylor shows us the importance of the spacers on the PANORAMO SI, and how to properly adjust them.
Protective Caps
In this Tech Tip, Service Technician Rick Norman explains the importance of the protective caps used on the connection ends of IBAK equipment.
Pushrod Retermination
RapidView Master Service Technician Josh Taylor demonstrates how to reterminate a pushrod cable from start to finish.
Mainline Cable Retermination
RapidView Master Service Technician Josh Taylor demonstrates how to reterminate a mainline cable from start to finish.
